EcoTechNews | Sustainable Innovation & Green Technology News

A news site that features articles about the environment and ecological technologies

Researchers performing seawater lithium extraction in a lab at Bhabha Atomic Research Centre (BARC).
Energy Ocean

BARC Method Recovers About 90% of Lithium From Seawater

A litre of seawater holds about 0.17 milligrams of lithium and more than 6,000 times as much magnesium, according to Down To Earth. Getting the lithium out anyway is the aim of a new seawater lithium extraction method from the Bhabha Atomic Research Centre (BARC) in India.

The reports describe a solvent system that recovers about 90% of the lithium and can be reused. The work is lab-scale, and it carries a practical cost: the solvent shrinks by roughly 10% every cycle.

The paper appeared in the journal Talanta (DOI 10.1016/j.talanta.2026.130545). Down To Earth names the authors as Vatsal Trivedi, Sai Krishna Devulapally, R Shekhar and G Venkateswarlu. They work at BARC’s National Centre for Compositional Characterization of Materials in Hyderabad. This article also draws on Research Matters and Electronics For You.

Why seawater lithium is so hard to capture

Research Matters puts the lithium dissolved in the oceans at roughly 180 to 230 billion tons. Down To Earth cites up to 230 billion tonnes.

Land supply is under pressure. The Chemical Abstracts Service (CAS) notes that brine extraction by solar evaporation is slow and can alter local ecosystems and water supplies. It adds that hard-rock mining uses a lot of chemicals and water.

Want to stay updated on renewable technology news and trends? Subscribe to get the latest innovations and global developments in sustainable energy and technology.

The ocean is the obvious alternative, but it is a hard chemistry problem. The lithium is dilute and sits beside far more magnesium. Down To Earth lists the usual complaints about direct extraction methods. They can be slow, their materials can degrade, and regeneration is awkward. Many also need costly chemicals and large solvent volumes.

Removing magnesium and calcium by raising the pH

The BARC process is solvent extraction. CAS describes this as separating lithium by how it divides between water and an organic liquid. Before that happens, the water gets treated.

The team raises the pH with sodium hydroxide and sodium carbonate. Magnesium and calcium drop out of solution, and the reports say more than 99% of these interfering ions are removed. Down To Earth says most of the lithium stays behind.

The DBM and MIBK solvent system for lithium extraction

The second step adds dibenzoylmethane (DBM) dissolved in methyl isobutyl ketone (MIBK). DBM binds the lithium. Many conventional systems also need extra synergistic chemicals to stabilise the resulting complex. Here, MIBK does that job as well as acting as the solvent, so the extra agents are not needed, as Electronics For You explains. Research Matters calls this approach “donor-free”.

Salt turns out to help. In dilute water, water molecules wrap tightly around lithium ions and hold them. Research Matters says the many ions in seawater weaken that shell through electrostatic forces, which lets the solvent reach the lithium. At higher pH, DBM sheds a proton and becomes the active binder, and MIBK steadies the neutral complex that forms.

The ratio of organic liquid to water is 0.1: 100 millilitres (3.4 fl oz) of solvent per litre (0.26 US gal) of water. Electronics For You says this cuts the initial solvent requirement compared with the conventional systems discussed in the paper.

Stripping the lithium with nitric acid and reusing the solvent

Dilute nitric acid strips the lithium into a separate solution and resets the solvent. Recovery stayed around 90% over five cycles, and the lithium grew more concentrated in the acid each time. Electronics For You adds that the team also tested the technique on spent lithium-ion batteries and coal fly ash.

Timing matters. Mixed for too long in such salty water, the two liquids form persistent emulsions, layers that refuse to separate. Down To Earth also mentions foam. CAS cautions separately that MIBK-type solvents add fire risk.

Lab-scale limits: how much seawater a kilogram of lithium takes

Start with the 90% figure. Electronics For You says the researchers extracted about 90% of the lithium from natural seawater. Research Matters ties the figure to the treated seawater. The readings are not equal. Lithium lost with the magnesium sludge in step one would only count under the first. Down To Earth says most of the lithium is retained, which is not the same as all.

Now the scale, using only the figures above. At 0.17 mg per litre and 90% recovery, one cubic metre of seawater yields about 0.15 g of lithium. A kilogram (2.2 lb) therefore means processing roughly 6,500 cubic metres, or about 1.7 million US gallons. That is my own rough arithmetic, not a number from the study.

The same figures raise two more questions. Magnesium at more than 6,000 times the lithium level is above a gram per litre, and nearly all of it has to be precipitated first. The reports do not say how much alkali that takes or what happens to the sludge. At 100 mL of solvent per litre, a kilogram of lithium also passes through about 650 cubic metres of solvent. If the 10% loss per cycle held at scale, that would be around 65 cubic metres lost per kilogram.

It may not hold. The sources call these physical losses, which a larger plant might reduce. Nobody has shown that yet. Electronics For You is clear that the study does not demonstrate industrial output or a cost per kilogram. Down To Earth lists the open questions: long-term performance, energy, chemical costs, marine environmental effects and scale. Down To Earth also describes the work as a “scientific breakthrough” and “revolutionary”, words this article does not adopt.

Other ways to extract lithium from seawater

BARC is not alone in working on seawater lithium. The results below use different measures, so they cannot be ranked against each other.

ApproachTeam and sourceWaterReported result
Solvent extraction after a pH stepBARC, via the three outlets aboveNatural seawaterAbout 90% lithium recovery; solvent reused over five cycles; lab-scale
Electrochemical, with hydrogen co-producedHaoshen Zhou’s group at Nanjing University, Nature Communications, 2 May 2026SeawaterLithium raised from 0.183 to 306.2 mg/L; net energy 6.40 Wh per gram of lithium
Adsorbent on a sunlight-and-gravity seesawZhejiang University and Argonne National Laboratory, per C&EN, 6 February 2026SeawaterLithium concentration boosted more than 15-fold
Solar transpiration deviceZhu Jia (Nanjing University) and Mi Baoxia (UC Berkeley), per the South China Morning Post, September 2024Brine, though the headline says seawaterExtracts and stores lithium using sunlight

India has its own reasons to care. Down To Earth says the country relies entirely on imports for raw lithium and battery-grade cells. Electronics For You adds that India has pursued overseas resources through Khanij Bidesh India Limited (KABIL). It also notes that the Geological Survey of India identified 5.9 million tonnes of inferred resources in Jammu and Kashmir in 2023. An inferred resource is not a proven, recoverable reserve.

Seawater lithium results are getting easy to find. What I would look for in the next BARC paper is the ratio of litres in to grams out, and what happens to the magnesium.

Acknowledgment of AI

Content developed using AI technology, reviewed to ensure clarity, coherence, and accuracy before publication

LEAVE A RESPONSE

Your email address will not be published. Required fields are marked *

With a background in telecommunications engineering, my career has been centered around reporting, product information management, and web development. For over a decade, I have also worked as a small business owner specializing in web services. I believe that as we continue to advance technologically, it is essential to remain conscious of the impact these innovations have on the planet. Whether it's through cutting-edge solutions in renewable energy, smart systems, or sustainable infrastructure, my focus is always on leveraging technology to foster a more environmentally responsible world. Outside of professional pursuits, I am continuously curious about the evolving relationship between humans, technology, and nature, and how we can integrate these elements for a better, more sustainable future.
Privacy Overview
EcoTechNews | Sustainable Innovation & Green Technology News

This website uses cookies

We use cookies to ensure the best possible user experience and to analyze website traffic. Cookies are stored in your browser and help us recognize you when you return to our site, as well as understand which sections of the website are most relevant and useful to you. You can manage your cookie preferences at any time.

Learn more about our cookie policy here

Strictly Necessary Cookies

Strictly necessary cookies must remain enabled at all times to store your preferences for cookie settings.

3rd Party Cookies

This website uses Google Analytics to collect anonymous information, such as the number of visitors and the most popular pages.